Experts in Turbocharging since 2003

Build Now, Pay Later

The offer is valid for all orders within the USA. For other countries, the cost will be automatically calculated on checkout.

Free Shipping Over $249

Eligibility: 68 Million in the US. Also allows UK, Canadian and Australian Forces.
Included:
  • - Active Duty (currently serving in the Armed Forces)
  • - Veterans (formerly served in the Armed Forces)
  • - Dependents (spouse or child of above)
Military Discount
+1 (602) 437-2101 Open M–F 8AM–4PM

Turbosmart IWG75 Single Port Internal Wastegate Actuator

SKU TS-IWG-SINGLEPORT

Turbosmart IWG75 Single Port Internal Wastegate Actuator

NEED HELP? CALL A PRODUCT EXPERT NOW AT 602-437-2101
$149.95
In stock
SKU
TS-IWG-SINGLEPORT

Turbosmart IWG75 Single Port Internal Wastegate Actuator

Turbosmart IWG75 Single Port Internal Wastegate Actuator

**For Twin Port EFR applications, check out Turbosmart's new GenV actuator.

The Turbosmart wastegate actuator range has been designed as a premium performance upgrade.  Most importantly the IWG75 gives you the ability to change the spring rate, putting you in control of your boost response!  On an internally wastegated turbo, the wastegate valve is built into the turbine housing. The wastegate valve is controlled by an internal wastegate actuator (aka canister).  As boost rises the actuator controls the position of the wastegate valve, which in turn controls the exhaust gas flow to the turbine.
 
The Turbosmart IWG-75 actuator range features:
  • Base spring pressure available from 3PSI to 26PSI
  • Stable boost control
  • Improved boost response
  • Flatter boost curve in the top end
  • A range of vehicle/turbo specific applications

The wastegate actuator allows for different combinations of spring pressures. All springs that are adaptable with the wastegate actuator are shown in the table below. To aid in the identification of these springs they are supplied colour coded. If this colour coding is not clear please use the dimensions in the following table to identify the spring. The springs chosen should be rated to the lowest boost level desired. Typically with a single port IWG, the stiffer the spring the earlier a given turbo will spool, since the WG does not bypass any exhaust gas during spoolup.

WARNING!

  • Fitting a heavier wastegate actuator spring may cause a higher than expected increase in boost pressure.
  • Turbosmart recommends adjusting your boost controller back to its minimum setting (or unplugging the solenoid) and measuring the new minimum boost pressure achieved by the new spring, before increasing your boost pressure again.
  • Use of a turbocharger speed sensor is a good idea if you plan to run very high boost levels

If a 3 Port Boost Control Solenoid is used, this is the correct plumbing orientation diagram:

 

SKU

TS-IWG-SINGLEPORT

WEIGHT

2.000000

BRAND

Turbosmart

Write A Review

similar products

For SHOP OWNERs
& KIT BUILDERs

Full-Race Motorsports is the most
trusted name in turbocharging.

Wholesale Inquiries
M-F: 8AM-4PM MST