Turbosmart IWG75 BorgWarner EFR Internal Wastegate Actuator
Turbosmart IWG75 Internal Wastegate Actuator BorgWarner EFR
Turbosmart IWG75 Internal Wastegate Actuator BorgWarner EFR
Turbosmart IWG75 BorgWarner EFR Internal Wastegate Actuator
**For Twin Port applications, check out Turbosmart's new GenV actuator
- Base spring pressure available from 3PSI to 26PSI
- Stable boost control
- Improved boost response
- Flatter boost curve in the top end
- A range of vehicle/turbo specific applications
All springs that are adaptable with the IWG75 wastegate actuator are shown in the table below. To aid in the identification of these springs they are supplied colour coded. If this colour coding is not clear please use the dimensions in the following table to identify the spring. The springs chosen should be rated to the lowest boost level deired. Typically with a single port IWG, the stiffer the spring the earlier a given turbo will spool, since the WG does not bypass any exhaust gas during spoolup.
WARNING!
- Fitting a heavier wastegate actuator spring may cause a higher than expected increase in boost pressure.
- Turbosmart recommends adjusting your boost controller back to its minimum setting (or unplugging the solenoid) and measuring the new minimum boost pressure achieved by the new spring, before increasing your boost pressure again.
- Use of a turbocharger speed sensor is a good idea if you plan to run very high boost levels
If a 3 Port Boost Control Solenoid is used, this is the correct plumbing orientation diagram:
SKU
TS-IWG-EFR
WEIGHT
2.000000
BRAND
Turbosmart
similar products
Mitsubishi Turbocharger | Evo IX Stock Turbo
MHI Mitsubishi Evolution 4-9 TF06-18K Turbo Upgrade
Gold Heat Reflecting Film Self Adhesive 12" X 24"
Full Race Turbo Blankets For T4 Turbochargers
Turbo Speed Sensor Kit
Walbro 450 LPH E85 Compatible Walbro Universal In-Tank Fuel Pump
Barb Fittings and Breather Filter for 4 Port Boost Control Solenoid
255LPH Walbro High Pressure In-Tank Fuel Pump
Walbro 525 LPH F90000285 E85 Hellcat Fuel Pump
Injector Dynamics ID2600 Fuel Injectors
10mm M10 Inconel Turbo Stud Hardware Kit T3 T4 Turbos
Injector Dynamics ID1300X Injectors
For SHOP OWNERs
& KIT BUILDERs
Full-Race Motorsports is the most
trusted name in turbocharging.