Full-Race Pro-AM DRAG traction bars use a heavy steel crossmember for hardcore drag racing specific weight bias. This increases front wheel traction by weighting the very front of the vehicle, optimizing CG and improving drag launches. Designed specifically for the 92-00 Honda Civic and 94-01 Acura DC Integra chassis, these traction bars are a must for drag-strip racers seeking to increase traction, lower 60 ft times, and eliminate wheel hop.
Full-Race’s ProAm style traction bar system incorporates a solid front motor mount. This motor mount prevents unwanted motor and transmission movement that is commonly seen on a high output vehicle. Engine vibrations will be increased somewhat with this type of motor mount. However, this mount can be easily removed in a few minutes with a basic set of hand tools. Simply install the mount when need be and remove it when it is not desired.
Full-Race recommends using the traction bars to gently pull the LCA towards the front of the car, just 1 or 2 turns. This allows a slight increase in caster, even from Left to Right
Installation Notes:
- There is approximately a 6mm / 1/4″ variation of production tolerance from honda civic and integra tow hook brackets. We build the traction bars to fit all chassis, and there is absolutely nothing at all wrong with tightening the hardware without washers. the tow hook brackets will flex outward and the traction rod connection points remain centered
- The “U” shaped Clevis is purposely oversized. This allows for easy installation of the heim joint + 2 misalignment spacers. Tighten it down once everything is installed and the “U” will compress into place
Reviews
There are no reviews yet.