Full-Race’s K-swap DRAG traction bars use a heavy steel crossmember for hardcore drag racing specific weight bias. This increases front wheel traction by weighting the very front of the vehicle, optimizing CG and improving drag launches. This particular traction bar utilizes a solid front motor mount. This prevents unwanted motor and transmission movement commonly seen on high output FWD vehicles. Engine vibrations will be increased somewhat with this type of motor mount. However, this mount can be easily removed in a few minutes with a basic set of hand tools. Simply install the mount when need be and remove it when it is not desired. Designed specifically for the 92-00 Honda Civic and 94-01 Acura DC Integra chassis with a K series engine swap this part is a must for dragstrip racers seeking to increase traction, lower 60 ft times, and eliminate wheel hop.
Full-Race recommends using the traction bars to gently pull the LCA towards the front of the car, just 1 turns. This allows a slight increase in caster, kept even from Left to Right
- ’92-’00 Civic with Honda K Series motor
- ’94-’01 Integra with Honda K Series motor
- There is approximately a 6mm / 1/4″ variation of production tolerance from honda civic and integra tow hook brackets. We build the traction bars to fit all chassis, and there is absolutely nothing at all wrong with tightening the hardware without washers. the tow hook brackets will flex outward and the traction rod connection points remain centered
- The “U” shaped Clevis is purposely oversized. This allows for easy installation of the heim joint + 2 misalignment spacers. Tighten it down once everything is installed and the “U” will compress into place
This picture shows how the DC/EG/EK traction bar clevis MUST be mounted in line and level with the lower control arm.
DO NOT mount the clevis perpendicular to the control arm (like this) or any orientation other than in line and level with the lower control arm.
**Click on thumbnail pictures above for larger images**