1999-2000 Honda Civic Si EM1 B-Series ProAm Traction Bar

This ProAm style traction bar is specific to the 99-00 Civic Si EM1 and utilizes an additional front motor mount. This motor mount is easily installed in non-AC applications to prevent unwanted motor and transmission movement commonly seen on high performance applications. Full-Race ProAm traction bars are intended for high power street, race, and road race cars.  Engine vibrations will be increased somewhat with this type of motor mount. This is the trade off if you're looking for a massive increase in traction, reduced wheel hop, and all-around better launches / quicker track times. This mount can be easily removed in a few minutes with a basic set of hand tools. Simply install the mount when needed and remove it when it is not desired. Full-Race recommends using the traction bars to gently pull the LCA towards the front of the car, just 1 or 2 turns. This allows a slight increase in caster, even from Left to Right

Installation Notes:

• There is approximately a 6mm / 0.25" variation of production tolerance from honda civic and integra tow hook brackets.  We build the traction bars to fit all chassis, and there is absolutely nothing at all wrong with tightening the hardware without washers.  the tow hook brackets will flex outward and the traction rod connection points remain centered
• The "U" shaped Clevis is purposely oversized.  This allows for easy installation of the heim joint + 2 misalignment spacers.  Tighten it down once everything is installed and the "U" will compress into place